Faulty internet connections or firmware faults could cause the D-link extender light blinking issues. Each LED has a unique significance. This means that you need to check the status and working order of each LED regularly as it can affect the device’s performance. The common error might arise due to a faulty internet connection which can be resolved. Get more information on this topic in this blog.
D-Link Extender Red Light Issue
The D-Link extender’s red light can indicate a network problem with the D-Link router. The D-Link extender’s solid red light emits blinking patterns that can raise or decrease depending on the error. This could indicate a technical problem with the router.
Reasons for blinking red light on extender:
- D-Link’s red LED status indicates an issue with the internet network.
- The ethernet cable must be in good condition and should not be damaged.
- Your internet connection should be stable and smooth. If the internet connection isn’t working, call your local Internet Service Provider to get his assistance.
D-Link Extender Blinking Orange Light Issue
A blinking orange light indicates that it is in recovery mode because of a firmware fault. In contrast, a solid orange light signifies that it’s just starting up. Possible solutions are given below to repair this glitch.
- Firstly download the correct firmware from D-link’s site.
- Also, you can set a static IP for your computer to 192.168.0.2
- Then press the reset button. For approximately 30 seconds, hold the reset button. To switch to firmware recovery mode, the Power LED will blink orange.
- Then go to http://192.168.0.1 on your PC web browser, and choose the firmware you have downloaded.
- Let the router flash an image. Don’t be alarmed if it restarts before reaching 100%. Your browser may not be supported if the page loads endlessly or repeatedly.
- You can obtain the new IP address from your router using DHCP.
Basic Troubleshooting Tips For The D-Link Extender
- If the extender is having problems, try restarting it. Sometimes, the problem is minor and can be resolved by a simple reboot.
- Then verify the Ethernet cable connections.
- Sometimes network interference can occur. Make sure there aren’t multiple networks within the area.
- It should not be heated beyond its recommended temperature.
- Also always keep your browser up-to-date. If the browser is not working correctly, try another browser.
- Then ensure you’re connected to the same wireless network as your extender base.
- Now deactivate internet security software. Do this as the internet security software might be blocking access to the configuration page.
- Then verify that your internet connection works. It should be working smoothly. If it isn’t working, contact your local Internet service provider.
- You might experience problems due to outdated firmware. You should ensure that your firmware is always up-to-date and that your device has all the latest features.
- Also avoid any loose wired connection as this could cause red and orange light problems.
Conclusion
In a matter of minutes, the D-Link extender light blinking problem is solved. Learn more about the possible solutions and get in touch with our tech for the same.